Plant Pot 211 Caps and Stands: Building a Simple Setup
By KINTO Japan | Published: 2026-11-03
Category: Handleidingen
A step-by-step guide to pairing the Plant Pot 211 160mm stand with a 135mm cap and pot, so your indoor setup stays stable, drains freely, and looks intentional.
Quick answer
Use the Plant Pot 211 160mm stand as the base, center a 135mm cap on it, and set your pot on the cap. This separates drainage from the stand, keeps the pot centered, and protects surfaces from water rings.
Why the cap and stand work as a pair
The stand lifts the pot off the floor or shelf, while the cap catches drips and adds a visual finish. Together they solve two common indoor problems: water marks on furniture and pots that tip when nudged. The stand's 7kg load rating is generous for a 160mm pot, but only if the weight sits centered and the pot does not overhang the edge.
When this setup is not the right fit
The stand is for indoor use only; outdoor exposure can degrade the powder-coated zinc alloy. Also, it is sized for pots up to about 160mm in diameter, so larger floor pots need a different stand. If your pot is much smaller than 135mm, the cap may look oversized and the pot can slide off-center.
Steps to build your setup
- Place the stand on a stable, indoor surface: Set the stand on a level shelf or floor away from electronics, valuables, and the reach of children or pets. Avoid outdoor use entirely. Check that all four feet sit flat and the stand does not wobble before adding weight.
- Center the 135mm cap on the stand: Lower the cap onto the stand's top ring, aligning its center with the stand's center. Press gently to seat it. If the cap rocks, lift and reseat it; a tilted cap will make the pot unstable.
- Set the pot on the cap and check alignment: Place your potted plant on the cap, then step back and confirm the pot, cap, and stand share the same center line. The pot should not overhang the cap edge. A pot that is off-center can tip or send water running onto the stand during watering.
- Water carefully and inspect for drips: Water slowly until a little drains into the cap, then stop. Empty the cap if water pools deeper than a few millimeters. Never let the pot sit in standing water; it can damage roots and leave rings on the stand.
- Tighten the stand screws if needed: If the stand feels loose, use a hex wrench to tighten the screws. Check them every few months. Loose screws reduce stability and can lead to a fall.
Product facts
- プラントポット 211_ 160mm スタンド: The stand is made of powder-coated zinc alloy with a 7kg load capacity and measures W157 x D136 x H185 mm. It is strong enough for most 160mm indoor pots, but the compact footprint means the pot must stay centered to avoid tipping.
プラントポット 211_ 160mm スタンド
